Liquidity Magnets [Zofesu]

Technical Logic:
This indicator identifies institutional liquidity zones and "Stop-Run" reversal patterns using Multi-Timeframe (MTF) analysis. It focuses on the areas where high-leverage liquidations are likely to occur.

Liquidation Magnets:
The script calculates theoretical liquidation zones based on major Swing Highs and Lows from a different timeframe (default 480 min).

• 10% Magnets (Red/Green): Represent deeper liquidity pools typically associated with 10x leverage liquidation points.
  
• 4% Magnets (Yellow): Represent tighter liquidity zones associated with higher leverage. These can be toggled on or off in the settings to maintain chart clarity.

Stop-Run Detection (Signal Sensitivity):
The indicator tracks "sweeps" of previous highs and lows. A signal is triggered when price pierces a swing level but fails to hold, indicating a liquidity grab.

• Sensitivity %: This unique feature (0–100%) filters signals based on how deep the sweep penetrates toward the 4% magnet line.
  
• 0%: Every raw sweep is signaled.
  
• 100%: Only sweeps that reach the full 4% liquidation distance are displayed.

Visuals:

• Triangles (Gray): Mark "Stop-Run" events where liquidity was swept and price reversed.
  
• Black/Dark Bars: Highlight the specific candles where the liquidity sweep occurred.
  
• Horizontal Lines: Plot the 4% and 10% magnet levels whenever a new swing point is detected on the selected timeframe.
  
• Line Length: Users can customize the horizontal extension (Length in bars) of these liquidity magnets to fit their chart scaling.

How to use:

1. Identify the Magnet: Watch for price approaching the 10% or 4% horizontal lines. These areas often act as "magnets" before a reversal.
   
2. The Sweep: Look for a Triangle signal (STOP-RUN) occurring near these magnet zones.
   
3. Execution: A bullish signal (Triangle Up) after sweeping a 4% or 10% lower magnet suggests a long entry as short-sellers are liquidated. A bearish signal (Triangle Down) at upper magnets suggests a short entry.
   
4. MTF Alignment: Use a different timeframe (e.g., 480m or Daily) for magnets to find key levels, while trading the signals on lower timeframes for precision.
   
5. Discretionary Trading: For a stricter approach, users can focus solely on the Red and Green liquidity magnets.
   
   • Bullish Setup: Price touches/sweeps the Green line (10% zone) and the subsequent candle closes back above it.
     
   • Bearish Setup: Price touches/sweeps the Red line (10% zone) and the subsequent candle closes back below it.
   
   This method allows for manual confirmation even if the built-in "Stop-Run" triangles are filtered out by high sensitivity settings.